INSTALLATION
There are two methods of installationFirst Method: Installation of two units of Dulcofilt.
1st Unit : Installating before a water tank.
2nd Unit: Installating after a water tank before a house.
Second Method: Installation of one unit of Dulcofilt
by installing after the water tank before a house.Two easy ways to clean the unit
1. Open the valve beneath the unit every month.
2. If the filter is dirty ( depending on the condition of
water in each place ) open the plastic cover and
take out the filter to clean it by using a tooth brush
and wash it with clean water . Put the filter back in
its place. This method will help prolong the life of
the filter
Why install Dulcofilt?
1st Unit:
Installing before a water tank will prevent precipitators
from accumulating in the water tank, especially the
underground tank which is not possible to clean.
2nd Unit:
Installing after a water tank before water flows into a
house in order to filter out small organisms which are
created in the water tank after keeping water in the
tank for a long time and also the organisms which
are created from the chlorine precipitator e.g. red
worms, parasites, and etc.
Dulcofilt is certified by ISO 9001
Widely used in Europe , America and Asla
Tested by DVGW
The outstanding characteristics of Dulcofilt which are different from other filter precipitators
* It resists water pressure up to 16 bars, while other
prevailing filter precipitators can resist water
pressure between 10-12 bars.
* Water flow rate of Dulcofilt is 3-4 m /hr, thus we
will not sense that the water flow is reduced.
* The filter of Dulcofilt is the most important part
which is insurpassable. It is produced from the
same polyester as used in medical services
and certified by Federal German Health
Authority ( KTW ) , and tested by DVGW
We are confident in its quality and guarantee its
performance.
